One is a high gain, internally frequency compen- sated operational amplifier, and the other is a precision volt- age comparator. Both the operational amplifier and the volt- age comparator have been specifically designed to operate from a single power supply over a wide range of voltages. Both circuits have input stages which will common-mode in- put down to ground when operating from a single power sup- ply. Operation from split power supplies is also possible and the low power supply current is independent of the magni- tude of the supply voltage. Application areas include transducer amplifier with pulse shaper, DC gain block with level detector, VCO, as well as all conventional operational amplifier or voltage comparator cir- cuits. Both circuits can be operated directly from the stan- dard 5 V DC power supply voltage used in digital systems, and the output of the comparator will interface directly with either TTL or CMOS logic.
|Published (Last):||17 March 2014|
|PDF File Size:||1.95 Mb|
|ePub File Size:||10.18 Mb|
|Price:||Free* [*Free Regsitration Required]|
Mot When considering short circuits to ground, the maximum output. This input current will only exist when the voltage at any of the input leads is driven negative. Operation from split power supplies is.
The dissipation is the total of both amplifiers datashedt use external. In addition, the low power drain. Input Common-Mode Voltage Range. Lead Temperature Soldering, 10 seconds. Absolute Maximum Ratings Note 1.
C, the LM must be derated based on a? Power Supply Rejection Ratio. This current is essentially constant, independent of the state of the output so.
Large Signal Response Time. C maximum junction temperature and a thermal resistance of. Distributors for availability and specifications.
The input common-mode voltage or either input signal voltage should not be allowed to go negative by more than 0. Life support devices or systems are devices or.
In addition to this diode action, there is also lateral NPN parasitic transistor action. National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.
Power Dissipation Note 2. Due to proximity of external components, insure that coupling is not originating via the stray capacitance between these external parts. At values of supply voltage in excess of 15V. The input voltage state must not be less. Both the operational amplifier and the. Both circuits have input stages which will. One is a high gain, internally frequency compen.
The upper end of the common-mode. Large Signal Voltage Gain. For the LM, temperature specifications are limited to 0? At output switch point, V O. Both circuits can be operated directly from the stan. Input Offset Voltage Drift.
The LM series consists of 2 independent building block. ESD rating to be determined. Please refer to the application hints section of the LM and the LM datasheets. Input Offset Current Drift. Output Short-Circuit to Ground Note 3.
For larger overdrive signals ns can be obtained. Vapor Phase 60 seconds. A critical component is any component of a life.
It is due to the collector-base junction of the input PNP. LMN Datasheet This is not destructive and normal output states will re-establish when the input voltage, which was negative, again returns.
The input voltage to the op amp should not exceed the power supply level. The response time specified is for a mV input step with 5 mV overdrive. Related Posts.
LM392N DATASHEET PDF
In addition to this diode action, there is also lateral NPN parasitic transistor action. The input voltage to the op amp should not exceed the power supply level. Both circuits can be operated directly from the stan. Large Signal Response Time.
Life support devices or systems are devices or. In addition to this diode action, there is also lateral NPN parasitic transistor action. Input Common-Mode Voltage Range. Power Supply Rejection Ratio.