Following are the main functions of PIC16F This pin is not dependent on the internal resets which also house the noise filter to detect and remove the small pulses in the path. Timer PIC16F comes with two timers where one is an 8-bit timer and other is bit timers. They can be employed both ways i. Both timers come with a clock select capability.

Author:Doujora Virn
Language:English (Spanish)
Published (Last):1 December 2012
PDF File Size:13.68 Mb
ePub File Size:11.23 Mb
Price:Free* [*Free Regsitration Required]

Schematics are shown for using infrared RF or radio RF media. If you are not familiar with microcontroller programming, you can use fixed encoder and decoder integrated circuits instead. The transmitter has a varying number of buttons and sends the states of these inputs to the receiver. The receiver device decodes the message and sets the outputs accordingly.

The information about which key is pressed is encoded and sent. You can press at most one key at a time on the encoder, and only the code for the pressed key is sent to the decoder. This is an efficient method for general remote control parallel channels — please see older codecs for such designs. The state of all inputs are encoded and sent. The input to the encoder is the state of buttons or TTL inputs. Every input channel state is encoded into each message sent to the decoder one bit per channel , so TTL inputs can change asynchronously, and any number and combination of buttons can be pressed and encoded, the same state is reproduced on the decoder outputs.

This method is suitable for modeling AND remote control, but messages are longer. Each transmitter and receiver has an address, and the transmitter address must match the address of the receiver to control the channels. The transmitters are capable of sending three different types of codes for the available channels: transmitting simple code indicating that the button for a channel is pressed — it can be used for momentary or toggled channel outputs transmitting channel ON codes — it is used for turning on latched channel outputs transmitting channel OFF codes — used for turning off latched channel outputs All the receivers have an indicator LED showing that a valid packet was received.

Receivers can have different type outputs for each channel: momentary output — the channel output is turned ON while the corresponding transmitter button is pressed latched output — the last received state is kept. The possible combinations are described below. The 8-channel transmitter can be used for controlling 8 channels by sending simple codes, the 4-channel transmitter can be used with four ON and four OFF buttons for 4 channels.

The diode wires J1-J4 determine the transmitter address. The number of channels and button functions depends on the PIC code used. IR transmitter schematic 8-channel V4. Each channel can be set to momentary or latched operation. The address is set by switch S1.

Each channel has both momentary AND latched outputs 2 outputs per channel. LM[] outputs are latched outputs of channels, and LM[] outputs are momentary outputs of channels. The 4-relay PCB can be re-wired to select momentary or latched output for the four relays.


PIC16F630 calibration code


ISO 128-82 PDF

Infra/radio remote control transmitter/receiver with PIC16F630







Related Articles